The GPS and GSM modules are integrated inside the tracking unit case. GPRS/ SMS and Voice I/O Up to 5.000 location / activation messages can be saved (automatic) Built in motion switch Battery charge circuit to charge 3.7 Volt Li-ion battery Panic input button (will power up the unit from deep sleep mode) Park Switch Super low battery use in deep sleep mode (low power timer on) (Up to 3 years with 3.7V/1100mA battery) Timer circuit can wake up unit by time (hours – minutes – seconds – days Months) or any configured time or date. Time backup battery will last up to 3+ years without battery or external power connected. 18 Pin mini multi I/O connector One digital inputs (0 to 60VDC) One analogue – digital input (3.3VDC) External battery backup option (to connect second battery or Solar panel option) USB to Serial (Serial RS232 port (9600 baud Rate)) for external communication, firmware upgrade or direct access to modem (9600 baud rate). Build in Amplified Speaker (1.25Watt output power) and Microphone Build in Active high performance GPS antenna Unit can be activated from deep sleep mode using Panic input, wire connection (will activate the unit when wire is broken or cut) or when closed loop is opened. Low battery led indicator Status and GPS led indicator Build in buzzer for warning and motion detection External option to connect Speaker and Mic Operating temperature range -25 deg. C to +70 deg. C (Battery 0 – +60 Degrees C.)
Physical Characteristics
Unit size: LxWxH 90.5x 39 x 15.5 mm (17.7 max) Plastic / Waterproof if required Case Environmental Characteristics: Operational Temperature: - 25 ~ + 70 °C (board temperature) Storage temperature -40°C to +80°C 1 Multi I/O connector (18 pin with locking pins) 1 On/Off switch / 1 Park switch / 1 Panic button
Electrical Characteristics
Input Voltage: + 5 Volt DC regulated (USB port power) Power Consumption: Depending on operating mode max up to 3 Years (using 3.7V/ 800 mA battery)
GSM Modem Specifications
Frequency bands
Tri-band: 900, DCS 1800, PCS 1900 or EGSM 850, DCS 1800, PCS 1900
Compliant to GSM Phase 2/2+ GSM class Small MS
Transmit power Class 4 (2W) at EGSM 900
Class 1 (1W) at DCS1800 and PCS 1900
GPRS connectivity GPRS multi-slot class 10
GPRS mobile station class B
DATA
GPRS:
CSD:
GPRS data downlink transfer: max. 85.6 kbps GPRS data uplink transfer: max. 42.8 kbps Coding scheme: CS-1, CS-2, CS-3 and CS-4 Supports the protocols PAP (Password Authentication Protocol) usually used for PPP connections. Integrated TCP/IP protocol. Support Packet Switched Broadcast Control Channel (PBCCH) CSD transmission rates: 2.4, 4.8, 9.6, 14.4 kbps, non-transparent Unstructured Supplementary Services Data (USSD) support SMS, MT, MO, CB, Text and PDU mode SMS storage: SIM card Support transmission of SMS alternatively over CSD or GPRS. SIM interface Supported SIM card: 1.8V ,3V
Audio features Speech codec modes
Half Rate (ETS 06.20) Full Rate (ETS 06.10) Enhanced Full Rate (ETS 06.50 / 06.60 / 06.80) Echo cancellation Noise reduction Phonebook management Supported phonebook types: SM, FD, LD, MC, RC, ON, ME,BN,VM,LA,DC,SD Application Toolkit Supports SAT class 3, GSM 11.14 Release 98 Real time clock Implemented Timer function Programmable via AT command Firmware upgrade Firmware upgradeable over serial interface
Power Use
Using 800 mA/ 3.7Volt battery
Timer - GPS – running – normal mode = 50mA Timer – GPS – GSM – running normal mode = 100mA Timer – running – normal mode – ADC working – All inputs = 7mA (No activation last 4 Days)
Stop mode – GPS/GSM off - Timer off – Activate by low power timer – Panic – or any digital input = 0.83 mA (No activation will last 40Days)
Stop mode 2 – GPS Off – GSM in sleep mode - Timer off – Activate by low power timer – Panic – SMS message or Call - or any digital input = 5 mA (No activation will last up to 6 Days)
Unit off – low power timer running. Can only wake up by Panic input or timer. (No activation will last up to 3 + Years)
